Huacam HCV712 Manuel d'utilisateur télécharger pdf (Page 38)

www.huacam.com 38

5.14 Configuration File Download

Huacam SIP Device can be configured via Web Interface as well as via Configuration File

through TFTP or HTTP/HTTPS. “Config Server Path” is the TFTP or HTTP/HTTPS server path

for configuration file. It needs to be set to a valid URL, either in FQDN or IP address format. The

“Config Server Path” can be same or different from the “Firmware Server Path”.

A configuration parameter is associated with each particular field in the web configuration page.

A parameter consists of a Capital letter P and 1 to 3 (Could be extended to 4 in the future) digit

numeric numbers. i.e., P2 is associated with “Admin Password” in the ADVANCED SETTINGS

page. For a detailed parameter list, please refer to the corresponding firmware release

configuration template.

When Huacam Device boots up or reboots, it will issue request for configuration file named

“cfgxxxxxxxxxxxx.xml”, where “xxxxxxxxxxxx” is the MAC address of the device, i.e.,

“cfg000b820102ab.xml”. The configuration file name should be in lower cases.

Currently HCV712 only support XML configuration.

6. Restore factory default setting

WARNING!

Restoring the Factory Default Setting will DELETE all configuration information of the camera.

Please BACKUP or PRINT out all the settings before approach to following steps. Huacam will

not take any responsibility if you lose all the parameters of setting or cannot connect to your VoIP

service provider.

6.1 Factory reset

Reset from Web Interface

1 2 ... 33 34 35 36 37 38 39 40 41 42 43

Pas de commentaire

Huacam HCV712 Manuel d'utilisateur Page 38